Toyota Celica, Corolla, ECHO & MR2 1999-05

Locks & Lock Systems

Print

Removal & Installation



Door Locks
  1. Turn the ignition key to the LOCK position. Disconnect the negative battery cable. All models are equipped with an air bag, so wait at least 90 seconds from the time the negative battery was disconnected to start work.
  2.  


CAUTION
All models are equipped with a Supplemental Restraint System (SRS), which uses an air bag. Whenever working near any of the SRS components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SRS, as described in Section 6.

  1. Remove the door panel and water shield. Remove the service hole cover.
  2.  
  3. Disconnect the door outside opening linkage. Remove the two mounting bolts and remove the door handle if in need of replacement.
  4.  
  5. Disconnect the lock cylinder control linkage.
  6.  
  7. Remove the lock knob and the child protector lock lever knob.
  8.  
  9. Remove the three lock assembly retaining screws and the door lock. If equipped with power locks, disconnect the electrical wiring.
  10.  
  11. To remove the lock cylinder, remove the lock cylinder retaining clip and pull the cylinder from the door.
  12.  

To install:

  1. Coat all the door lock sliding surfaces with multi-purpose grease.
  2.  
  3. Install the outside handle with the two retaining bolts, if removed.
  4.  
  5. Install the door lock solenoid linkage to the door lock.
  6.  
  7. Connect the link to the outside handle.
  8.  
  9. Install the lock knob and the child protector lock lever knob.
  10.  
  11. Install the door opening control link.
  12.  
  13. Install the door lock cylinder control linkage.
  14.  
  15. Install the door panel and water shield.
  16.  
  17. Reconnect the negative battery cable.
  18.  

Hatch/Tailgate/Trunk Lid Lock Cylinder

Remove the inside trunk garnish. Remove the bolts and the door lock control with the solenoid, if equipped. The installation is the reverse of the removal procedure.

Tailgate Lock
  1. Remove the back door inside garnish.
  2.  
  3. Remove the link protector.
  4.  
  5. Disconnect the links from the door control and door lock cylinder.
  6.  
  7. Remove the bolts and the door lock control with the solenoid.
  8.  
  9. To remove the door lock cylinder, remove the retaining screws and then remove the cylinder.
  10.  

To install:

  1. Install the door lock cylinder and secure with the retaining screws.
  2.  
  3. Install the bolts and the door lock control with the solenoid.
  4.  
  5. Connect the links to the door control and door lock cylinder.
  6.  
  7. Install the link protector.
  8.  
  9. Install the back door inner garnish.
  10.  

 
label.common.footer.alt.autozoneLogo