Toyota Celica, Corolla, ECHO & MR2 1999-05

Back-up Light Switch

Print

The back-up light switch is mounted on top of the manual transaxle assembly.

Removal & Installation



  1. Disconnect the electrical harness from the back-up switch, which is mounted on the transaxle case.
  2.  
  3. Loosen and remove the back-up light switch from the transaxle case.
  4.  
  5. Remove the gasket. Discard the gasket.
  6.  

To install:

  1. Install the new gasket onto the switch.
  2.  
  3. Screw the switch with gasket into the transaxle case and tighten to 33 ft. lbs. (44 Nm).
  4.  
  5. Attach the back-up light switch electrical connector.
  6.  

 
label.common.footer.alt.autozoneLogo