Removal & Installation
- Loosen the rear wheel lug nuts. Raise the rear of the vehicle with a floor jack and support the body with safety stands. Remove the rear wheels.
- Remove the exhaust tail pipe.
- On some vehicles, it may be necessary to support the fuel tank and remove the tank band from the body.
- Remove the four nuts and two stabilizer bar links. If the ball joint turns when removing the nut, use a wrench to stabilize the stud.
- Disconnect the stabilizer bar from the body by removing the nuts. Remove the stabilizer bar from the vehicle with bushings and brackets. If the bushings appear to be worn or cracked, replace them.
Install the bushing to the outside of the pant line. Install the bushing to the stabilizer bar so that the cutout of the bushings faces the front of the vehicle.
- Temporarily connect the stabilizer bar to the body with the bushings, brackets and bolts.
- Connect the stabilizer bar links to the No. 1 suspension arm with the retainers, cushions and nuts. Tighten the center bracket bolts to 14 ft. lbs. (19 Nm). Tighten the stabilizer-to-body bolts to 14 ft. lbs. (19 Nm) and the stabilizer link to stabilizer bar bolts to 33 ft. lbs. (44 Nm).
- Install the right side fuel tank band and tighten the bolts to 30 ft. lbs. (40 Nm).
- Install the rear exhaust tail pipe. Tighten the retaining nuts and bolts to 32 ft. lbs. (43 Nm).
- Install the rear wheels and remove the safety stands.
- Lower the vehicle and bounce the rear end a few to times to allow the rear suspension to stabilize.
- Have the rear wheel alignment checked.