The automobile charging system provides electrical power for operation of the vehicle's ignition system, starting system and all the electrical accessories. The battery serves as an electrical surge or storage tank, storing (in chemical form) the energy originally produced by the belt driven alternator. The system also provides a means of regulating alternator output to protect the battery from being overcharged and to avoid excessive voltage to the accessories.
The storage battery is a chemical device incorporating parallel lead plates in a tank containing a sulfuric acid-water solution. Adjacent plates are slightly dissimilar, and the chemical reaction of the two dissimilar plates produces electrical energy when the battery is connected to a load such as the starter motor. The chemical reaction is reversible, so that when the alternator is producing a voltage greater then that produced by the battery, electricity is forced into the battery, and the battery is returned to its fully charged state.
The vehicle's alternator is driven mechanically, through a V-belt (or serpentine belt depending upon the application), by the engine crankshaft. It consists of two coils of fine wire, one stationary (the stator), and one movable (the rotor). The rotor may also be known as the armature and consists of fine wire wrapped around an iron core which is mounted on a shaft. The electricity which flows through the two coils of wire (provided initially by the battery in some cases) creates an intense magnetic field around both rotor and stator, and the interaction between the two fields creates voltage, allowing the alternator to power the accessories and charge the battery.
There are generally 2 types of alternators; the earlier of the 2 (often known as a generator) is the direct current (DC) type. The DC generator voltage is produced in the armature and carried off the spinning armature by stationary brushes contacting the commutator. The commutator is a series of smooth metal contact plates on the end of the armature. The commutator plates, which are separated from one another by a very short gap, are connected to the armature circuits so that current will flow in one direction only in wires carrying the generator output. The generator stator consists of two stationary coils of wire which draw some of the output current of the generator to form a powerful magnetic field and create the interaction of fields which generates the voltage. The generator field is wired in series with the regulator.
Newer automobiles use alternating current generators or alternators because they are more efficient, can be rotated at higher speeds, and have fewer brush problems, In an alternator, the field rotates while all the current produced passes only through the stator windings. The brushes bear against continuous slip rings rather than a commutator. This causes the current produced to periodically reverse the direction of its flow. Diodes (electrical one-way switches) block the flow of current which is prevented from traveling in the wrong direction. A series of diodes is wired together to permit the alternating flow of the stator to be converted to a pulsating, but unidirectional, flow of current from traveling in the wrong direction. The alternator's field is wired in series with the voltage regulator.
The regulator consist of several circuits. Each circuit has a core, or magnetic coil of wire, which operates a switch. Each switch is connected to ground through one or more resistors. The coil of wire responds directly to system voltage. When the voltage reaches the required level, the magnetic field created by the winding of wire closes the switch and inserts a resistance into the generator field circuit, thus reducing the output. The contacts of the switch cycle open and close many times each second to precisely control voltage.
While alternators are self-limiting as far as maximum current is concerned, DC generators employ a current regulating circuit which responds directly to the total amount of current flowing through the generator circuit rather than to the output voltage. The current regulator is similar to the voltage regulator except all system current must flow through the energizing coil on its way to the various accessories.
Observing these precautions will help avoid damage to the vehicle's electrical system and ensure safe handling of the system components: