Toyota Cressida/Corona/Crown/MarkII 1970-1982 Repair Guide

Upper Control Arm

Print

REMOVAL & INSTALLATION



  1. Remove the upper arm mounting nuts from inside the engine compartment, but do not remove the bolts.
  2.  
  3. Raise the vehicle, support the lower arm and remove the wheel.
  4.  
  5. On vehicles equipped with a ball joint wear sensor, remove the wiring from the clamp on the arm.
  6.  
  7. Remove the upper ball joint.
  8.  
  9. Remove the control arm mounting bolts.
  10.  
  11. Pry out the arm with a prybar.
  12.  
  13. Install in reverse of removal. Do not tighten the fasteners until the vehicle is on the ground.
  14.  
  15. Lower the vehicle and tighten the control arm mounting bolts to 95-130 ft. lb.
  16.  

 
label.common.footer.alt.autozoneLogo