Toyota Cressida/Corona/Crown/MarkII 1970-1982 Repair Guide

Circuit Opening Relay

Print

TESTING



This relay is on Cressida models only.

  1. Remove the left kick panel or glove box.
  2.  
  3. Using a voltmeter, check that the meter indicates voltage at Fp terminal during engine cranking and running.
  4.  
  5. Stop the engine.
  6.  
  7. Disconnect the wiring harness leading to the relay.
  8.  
  9. Measure the resistance between each terminal. The correct values are:

    Terminals STA-E1: 30-60 ohms
     
    Terminals B-Fc: 80-120 ohms
     
    Terminals B-Fp: Infinity
     

  10.  
  11. Plug the wiring harness into the relay.
  12.  
  13. Install the kick panel or glove box.
  14.  

 
label.common.footer.alt.autozoneLogo