Toyota Cressida/Corona/Crown/MarkII 1970-1982 Repair Guide

Door Glass

Print

REMOVAL & INSTALLATION



  1. Lower the window fully.
  2.  
  3. Remove the door inner trim panel.
  4.  
  5. Remove the service hole cover.
  6.  
  7. Remove the side view mirror.
  8.  
  9. Remove the top of the weatherstrip on both sides of the door, remove the screws and the belt molding if necessary.
  10.  
  11. Raise the window about an inch and remove the bolt holding the window guide in place. Pull the window guide upward out of the door.
  12.  
  13. Move the window downward and remove the forward stabilizer hook.
  14.  
  15. Move the window forward and down and remove the rear stabilizer hook.
  16.  
  17. Separate the regulator roller by sliding it from the door glass bracket.
  18.  
  19. Remove the door glass by pulling it upward.
  20.  
  21. Installation is the reverse of removal.
  22.  

 
label.common.footer.alt.autozoneLogo