Toyota Cressida/Corona/Crown/MarkII 1970-1982 Repair Guide

Seat Belts

Print

REMOVAL & INSTALLATION





Click image to see an enlarged view

Fig. Fig. 1 Exploded view of the seat belt routing-1971-72 Crown



Click image to see an enlarged view

Fig. Fig. 2 Exploded view of the seat belt routing-1977-78 Corona



Click image to see an enlarged view

Fig. Fig. 3 Exploded view of the seat belt routing-1978-80 Cressida



Click image to see an enlarged view

Fig. Fig. 4 Exploded view of the seat belt routing-1981-82 Cressida

The following procedures are to be used as reference. All of these models slightly differ, and the instructions may need altering.

Front
  1. Remove the trim cover at the upper shoulder anchor bolt.
  2.  
  3. Remove the anchor bolt.
  4.  
  5. Remove the lower cover on the outer retractor from the inner floor panel.
  6.  
  7. Remove the retractor portion of the seat belt.
  8.  
  9. To remove the buckle end of the seat belt, remove the cover on the base of the belt and the mounting bolt.
  10.  
  11. Installation of the belt is reverse removal. Tighten the mounting bolts.
  12.  

Rear
  1. Remove the trim cover at the upper shoulder anchor bolt.
  2.  
  3. Remove the upper anchor bolt.
  4.  
  5. Unbolt the outer belt anchor from the body panel. Removal of the rear seat belt is required. Unbolt the lower end of the belt under the retractor from the side panel.
  6.  
  7. Remove the retractor portion of the seat belt.
  8.  
  9. To remove the center belt buckle off the seat belt, remove the seat cushion and the belt mounting bolt.
  10.  
  11. Installation of the belt is reverse of removal. Tighten the mounting bolts.
  12.  

 
label.common.footer.alt.autozoneLogo