Toyota Cressida/Corona/Crown/MarkII 1970-1982 Repair Guide

Washer Pump

Print

REMOVAL & INSTALLATION



  1. Remove the washer reservoir from the vehicle.
  2.  
  3. Unhook the wiring harness for the pump.
  4.  
  5. Disconnect the wiring harness from the pump, then remove the pump from the reservoir. Check the grommet.
  6.  

To install:

  1. Install the pump into the reservoir.
  2.  
  3. Connect the wiring for the pump.
  4.  
  5. Install the reservoir.
  6.  
  7. Attach the wiring to the pump, then run the hose for the pump along the side of the reservoir.
  8.  
  9. Seat the reservoir into the engine compartment. Secure with the mounting bolt.
  10.  

 
label.common.footer.alt.autozoneLogo