Toyota Cressida/Corona/Crown/MarkII 1970-1982 Repair Guide

Wiper Linkage

Print

REMOVAL & INSTALLATION



Corona
  1. Remove the wiper motor.
  2.  
  3. Loosen the wiper arm retaining nuts and remove the arms.
  4.  
  5. Remove the wiper pivot nuts and lift out the linkage through the access hole.
  6.  
  7. Installation is the reverse of removal.
  8.  

Mark II 4 Cylinder

The linkage is removed along with the motor.

Mark II 6 Cylinder and Cressida
  1. Remove the wiper arms.
  2.  
  3. Remove the left and right cowl ventilators.
  4.  
  5. Remove the ventilator service hole cover.
  6.  
  7. Remove the linkage attaching screws.
  8.  
  9. Remove the wiper motor access cover.
  10.  
  11. Unfasten the wiper linkage from the motor crank. (See the wiper motor removal procedures).
  12.  
  13. Withdraw the linkage through the access hole.
  14.  
  15. Installation is performed in the reverse order of removal.
  16.  

Crown
  1. Perform Steps 1-5 of the Mark II 6 Cylinder Linkage Removal procedure.
  2.  
  3. Remove both of the pivots and the connecting linkage. Be careful not to damage the windshield washer nozzle.
  4.  
  5. Installation is performed in the reverse order of removal.
  6.  

 
label.common.footer.alt.autozoneLogo