Toyota Cressida and Van 1983-1990

Stoplight Switch

Print

ADJUSTMENT



  1. Remove the instrument lower finish panel and the air duct if required to gain access to the stop light switch.
  2.  
  3. Unplug the stoplight switch connector.
  4.  
  5. Loosen the switch locknut.
  6.  
  7. Turn the stoplight switch until the end of the switch lightly contacts the pedal stopper.
  8.  
  9. Hold the switch and tighten the locknut.
  10.  
  11. Attach the switch connector.
  12.  
  13. Depress the brake pedal and verify that the brake lights illuminate.
  14.  
  15. Install the air duct and the lower finish panel, if removed.
  16.  

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the instrument lower finish panel and the air duct if required to gain access to the stop light switch.
  4.  
  5. Unplug the stoplight switch connector.
  6.  
  7. Remove the switch mounting nut, then slide the switch from the mounting bracket on the pedal.
  8.  

To install:

  1. Install the switch into the mounting bracket and adjust as described above.
  2.  
  3. Attach the switch connector.
  4.  
  5. Depress the brake pedal and verify that the brake lights illuminate.
  6.  
  7. Install the air duct and the lower finish panel, if removed.
  8.  

 
label.common.footer.alt.autozoneLogo