Toyota Cressida and Van 1983-1990

Back-up Light Switch

Print

REMOVAL & INSTALLATION



  1. Raise the vehicle and safely support.
  2.  
  3. Unplug the switch.
  4.  
  5. Remove the switch. If the plunger is stuck, the switch is defective and should be replaced.
  6.  

To install:

  1. Replace the sealing washer when installing the switch.
  2.  
  3. Lower the vehicle and check the operation of the reverse lights.
  4.  

 
label.common.footer.alt.autozoneLogo