Toyota Cressida and Van 1983-1990

Speedometer Driven Gear

Print

REMOVAL & INSTALLATION





Click image to see an enlarged view

Fig. Fig. 1 The speedometer cable attaches to the driven gear located inside the manual transmission

  1. Raise the vehicle and safely support.
  2.  
  3. Disconnect the speedometer cable.
  4.  
  5. Remove the speedometer driven gear housing lock plate, then remove the gear from the housing by removing the clip.
  6.  
  7. Using a suitable tool, remove the oil seal from inside the housing sleeve, if necessary.
  8.  

To install:

  1. Install the new seal into the sleeve using seal installer tool 09201-60011, or equivalent.
  2.  
  3. Install the speedometer driven gear to the housing and install the clip.
  4.  
  5. Replace the housing O-ring and coat it with oil.
  6.  
  7. Install the assembly to the transmission and tighten the lock plate bolt to 8 ft. lbs. (11 Nm).
  8.  
  9. Check for proper speedometer operation.
  10.  

 
label.common.footer.alt.autozoneLogo