Toyota Cressida and Van 1983-1990

Steering Sensor

Print

TESTING





Click image to see an enlarged view

Fig. Fig. 1 Place the mode select switch in the Normal mode-Cressida



Click image to see an enlarged view

Fig. Fig. 2 When testing the TEMS steering sensor indicator light, make sure it flashes after two seconds



Click image to see an enlarged view

Fig. Fig. 3 While turning the steering wheel to the right, the No. 1 indicator light should be out while the No. 2 light flashes-Cressida



Click image to see an enlarged view

Fig. Fig. 4 While turning the steering wheel to the left, the No. 2 indicator light should be out while the No. 1 light flashes-Cressida

  1. Position the front wheel in the straight-ahead position. Place the mode select switch in the Normal position.
  2.  
  3. Using a jumper wire, short the service connector terminals Tem and E2. Turn the ignition switch to the ON position and check that the indicator lights flash after two seconds. If not, there is a problem with either the mode select switch, service connector circuit or TEMS computer.
  4.  
  5. Turn the steering wheel 1 / 4 turn to the right from the straight-ahead position and check that the No. 2 indicator light (right side) flash and the No. 1 light (left side) goes out.
  6.  
  7. Return the steering wheel to the straight-away position and then 1 / 4 turn to the left, and check that the No. 1 TEMS indicator light (left side) flash and the No. 2 light (right side) goes out.
  8.  
  9. If the operation is not as specified in the last two steps, inspect for the cause.
  10.  

 
label.common.footer.alt.autozoneLogo