Toyota Highlander 6 2001-06

Removal & Installation

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the center instrument cluster finish panel, as follows:
    1. Place the shift lever into the N position for more working room, and set the parking brake.
    2.  
    3. Using a suitable trim panel removal tool, disengage the 8 clips.
    4.  
    5. Disconnect the connectors, then remove the center instrument cluster finish panel

      Click image to see an enlarged view

      Fig. Removing the center instrument cluster panel

    6.  

  4.  
  5. Remove the radio/integration control and panel as follows:
    1. Remove the 6 bolts.
    2.  
    3. Disconnect the connectors, then remove the radio receiver and integration control panel.

      Click image to see an enlarged view

      Fig. Removing radio and control panel

    4.  

  6.  
  7. Separate the radio receiver, as follows:
    1. Remove the 4 bolts, 2 screws and radio bracket no. 1.
    2.  
    3. Remove the 4 bolts, 2 screws and radio bracket no. 2.
    4.  
    5. Remove the radio receiver from the integration control panel.
    6.  

  8.  
  9. Installation is the reverse of the removal procedure.
  10.  

Highlander Hybrid



  1. Remove instrument cluster finish panel center sub-assembly, using a prytool or screwdriver protected by tape to prevent damage
  2.  
  3. Remove integration control and panel assembly, as follows:
    1. Remove the 6 bolts.
    2.  
    3. Release the connector and remove the integration control and panel assembly.
    4.  

  4.  
  5. Remove radio receiver assembly.
    NOTE
    If further disassembly is required, perform the following steps.

  6.  
  7. Remove 3 control knobs (with manual A/C).
  8.  
  9. Remove the 2 control knobs (with auto A/C).
  10.  
  11. Remove heater control name sheet no.1 (with manual A/C).
  12.  
  13. Using a prytool or screwdriver protected by tape to prevent damage, remove the heater control name sheet No.2.
  14.  
  15. Remove the heater control retainer:
    1. Release the lock of connector and disconnect the cable.
    2.  
    3. Remove the 8 screws and heater control retainer.
    4.  

  16.  
  17. remove the air conditioner amplifier assembly, as follows:
    1. Remove the 3 screws and air conditioner amplifier assembly from the heater control retainer.
    2.  

  18.  
  19. Remove the 2 screws and the heater blower switch (with manual A/C).
  20.  
  21. Installation is the reverse of the removal procedure.

    Click image to see an enlarged view

    Fig. Exploded view of the control panel and related components-with manual A/C



    Click image to see an enlarged view

    Fig. Exploded view of the control panel and related components-with auto A/C

  22.  

 
label.common.footer.alt.autozoneLogo