Toyota Land Cruiser, Sequoia 6 2001-06

Fuel Pressure Regulator

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Relieve the fuel system pressure.
  4.  
  5. Put a shop towel under the pressure regulator.
  6.  
  7. Disconnect the vacuum hose from intake air resonator.
  8.  
  9. Disconnect the fuel return hose from the pressure regulator.
  10.  
  11. Remove the 2 bolts, and pull out the pressure regulator.
  12.  
  13. Remove the O-ring from the pressure regulator.

    Click image to see an enlarged view

    Fig. Vacuum hose and return hose

  14.  

To install:

  1. Apply a light coat of gasoline to a new O-ring, and install it to the pressure regulator.
  2.  
  3. While turning the pressure regulator left and right, install it to the delivery pipe.
  4.  
  5. Install the pressure regulator with the 2 bolts and tighten to 7.5 Nm (66 in. lbs.).
  6.  
  7. Connect the vacuum hose to intake air resonator.
  8.  
  9. Connect the fuel return hose to the pressure regulator.
  10.  
  11. Start the engine and check for fuel leaks.

    Click image to see an enlarged view

    Fig. Installing the pressure regulator

  12.  

 
label.common.footer.alt.autozoneLogo