Toyota Land Cruiser, Sequoia 6 2001-06

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Front wheel
     
    Under cover
     

  4.  
  5. Drain the differential oil.
  6.  
  7. Remove or disconnect the following:

    Grease cap
     
    Cotter pin and lock cap
     
    Halfshaft locknut by applying the brakes
     
    Lower control arm from the lower ball joint
     
    Halfshaft from the steering knuckle, using a plastic hammer
     
    Left strut, for the left halfshaft
     
    Right halfshaft, using a brass bar and a hammer
     
    Left halfshaft, using tools 09520-01010 and 09520-24010
     
    Snapring from the inboard joint shaft
     

  8.  


    Click image to see an enlarged view

    Fig. View of the halfshaft and related components-Sequoia


To install:

  1. Install or connect the following:

    New snapring, onto the inboard joint shaft with the opening facing downward
     
    Halfshafts to the differential using a brass bar and a hammer
     
    Halfshafts to the steering knuckles
     

  2.  


WARNING
Be careful not to damage the oil seal, boot or dust seal.



Lower control arm to the lower ball joint using a new cotter pin. Torque the ball joint nut to 103 ft. lbs. (140 Nm).
 
Halfshaft locknut by applying the brakes. Torque the nut to 173 ft. lbs. (235 Nm).
 
Lock cap and a new cotter pin
 
Grease cap
 

  1. Refill the differential with oil.
  2.  
  3. Install or connect the following:

    Under cover
     
    Front wheel
     

  4.  

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Front wheel
     
    Brake caliper
     
    Grease cap
     
    Snapring
     
    Wheel speed sensor and wire harness
     
    Steering knuckle arm
     
    Lower ball joint
     
    Upper ball joint
     
    Steering knuckle
     
    Axle halfshaft
     

  4.  


    Click image to see an enlarged view

    Fig. Halfshaft and related components-Land Cruiser



    Click image to see an enlarged view

    Fig. Axle halfshaft removal-Land Cruiser


To install:


NOTE
Use new split pins, snaprings and circlips for assembly.

  1. Install or connect the following:

    Axle halfshaft
     
    Steering knuckle
     
    Upper ball joint. Tighten the nut to 81 ft. lbs. (110 Nm).
     
    Lower ball joint. Tighten the nut to 117 ft. lbs. (159 Nm).
     
    Steering knuckle arm. Tighten the bolts to 108 ft. lbs. (147 Nm).
     
    Wheel speed sensor and wire harness
     
    Snapring
     
    Grease cap
     
    Brake caliper
     
    Front wheel
     

  2.  

 
label.common.footer.alt.autozoneLogo