Toyota Matrix 2003-06

Rear Window Wiper/Washer System

Print

Wiper Motor



  1. Remove the rear wiper arm cover.
  2.  
  3. Remove the rear wiper arm cover.
  4.  
  5. Remove the nut and the rear wiper arm and blade assembly.
  6.  
  7. Remove rear wiper link cap
  8.  
  9. Using a 24 mm deep socket wrench , remove the windshield washer packing nut rear wiper link pivot.
  10.  
  11. Open the back door glass and release the 9 claws, then remove the rear wiper motor cover.
  12.  
  13. Disconnect the 2 rear defogger connectors.
  14.  
  15. Remove the 2 nuts and the rear wiper motor and bracket assembly with the shaft cover assembly.
  16.  
  17. Disconnect the connector.
  18.  
  19. Remove the nut and junction switch.
  20.  
  21. Remove the 3 screws and the rear wiper motor and bracket assembly.
  22.  
  23. Remove the 3 bolts and the rear wiper motor assembly.

    Click image to see an enlarged view

    Fig. Using a 24 mm deep socket wrench , remove the windshield washer packing nut rear wiper link pivot

    Using a 24 mm deep socket wrench , remove the windshield washer packing nut rear wiper link pivot

    Click image to see an enlarged view

    Fig. Remove the 3 screws and the rear wiper motor and bracket assembly

    Remove the 3 screws and the rear wiper motor and bracket assembly

    Click image to see an enlarged view

    Fig. Remove the 3 bolts and the rear wiper motor assembly

    Remove the 3 bolts and the rear wiper motor assembly
  24.  

To install:

  1. Install the rear wiper motor grommet as shown.

    Click image to see an enlarged view

    Fig. Install the rear wiper motor grommet as shown

    Install the rear wiper motor grommet as shown
  2.  
  3. Install the rear wiper motor assembly with the 3 bolts. Tighten to 49 in. lbs. (5.5 Nm).
  4.  
  5. Install the rear wiper motor and bracket with the 3 screws.
  6.  
  7. Connect the connector.
  8.  
  9. Install the junction switch with the nut.
  10.  
  11. Connect the rear defogger connectors.
  12.  
  13. Install the rear wiper motor and bracket assembly with shaft cover assembly with the 2 nuts. Tighten to 49 in. lbs. (5.5 Nm).
  14.  
  15. Using a 24 mm deep socket wrench, install the windshield washer packing nut rear wiper link pivot with the nut. Tighten to Tighten to 62 in. lbs. (7 Nm).
  16.  
  17. Install the rear wiper arm and blade assembly with the nut. Tighten to 49 in. lbs. (5.5 Nm).
  18.  

 
label.common.footer.alt.autozoneLogo