Toyota Pick-ups/Land Cruiser/4Runner 1970-1988

Door Glass and Regulator

Print

REMOVAL & INSTALLATION



Glass w/o Vent Window
  1. Lower the window.
  2.  
  3. Remove the door trim panel and the service hole cover.
  4.  
  5. On later models, remove the armrest base and the inside door handle.
  6.  
  7. Remove the inner and outer weather-strips.
  8.  
  9. Remove the 2 door glass channel mounting bolts and pull the window up and out of the door. Pry the glass channel from the bottom of the window.
  10.  
  11. Coat the inside of the weather strip with soapy water and tap the glass channel onto the bottom of the window.
  12.  
  13. Slide the window into the door until the 2 glass channel mounting bolts can be fitted. Tighten the bolts.
  14.  
  15. Install the weather strips. Install the armrest base and inside door handle.
  16.  
  17. Install the service hole cover and the door trim panel.
  18.  

Glass W/Vent Window
  1. Lower the window.
  2.  
  3. Remove the door trim panel and the service hole cover.
  4.  
  5. On later models, remove the armrest base and the inside door handle.
  6.  
  7. Remove the inner and outer weather-strips.
  8.  
  9. Remove the glass run and the rear lower frame.
  10.  
  11. Remove the 2 glass channel mounting bolts and place the window on the bottom of the door cavity.
  12.  
  13. Peel off the weatherstrip on the upper side of the vent window. Remove the 3 screws and the division bar set bolt. Pull the vent window up and out of the door frame.
  14.  
  15. Pull the main window up and out of the door. Pry the glass channel from the bottom of the window.
  16.  

To install:
  1. Coat the inside of the weatherstrip with soapy water and tap the glass channel onto the bottom of the window.
  2.  
  3. Slide the main window into the door until the 2 glass channel mounting bolts can be fitted.
  4.  
  5. Position the vent window and install the 3 mounting screws and the set bolt. Tighten the 2 glass channel mounting bolts.
  6.  
  7. Install the weather-strips. Install the armrest base and inside door handle.
  8.  
  9. Install the service hole cover and the door trim panel.
  10.  

Regulator
  1. Remove the door trim panel.
  2.  
  3. Remove the service hole cover.
  4.  
  5. Remove the window.
  6.  
  7. If the truck has power windows, disconnect the electrical lead from the motor.
  8.  
  9. Remove the regulator mounting bolts and lift it out through the service hole. On models without a vent window, remove the 2 equalizer arm bracket mounting bolts.
  10.  
  11. Install the regulator and tighten the mounting bolts. On models with a vent window, install the 2 equalizer arm bracket mounting bolts.
  12.  
  13. Connect the lead to the power window motor if equipped.
  14.  
  15. Install the window, service hole cover and door trim panel.
  16.  

 
label.common.footer.alt.autozoneLogo