Toyota Pick-ups/Land Cruiser/4Runner 1989-1996

Igniter

Print

REMOVAL & INSTALLATION



See Figures 1, 2, 3 and 4

Igniters are mounted in one of two places on your Toyota truck. On the remotely mounted coils, the igniter is secured to the coil. On the integral coil vehicles (where the coil is in the distributor) the igniter is secured to the fenderwell.

  1. Disconnect the negative battery cable.
  2.  
  3. Separate the wiring harness connections.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: The igniter can be found mounted on the remote ignition coil

  1. Unbolt the igniter.
  2.  



Click image to see an enlarged view

Fig. Fig. 2: Unplug the connector and remove the retaining screws

  1. If mounted to the coil, loosen the nut holding the wire lead.
  2.  



Click image to see an enlarged view

Fig. Fig. 3: If mounted to the coil, detach the wire

  1. Tag and disconnect the wire lead.
  2.  
  3. Lift the igniter off its mount.
  4.  



Click image to see an enlarged view

Fig. Fig. 4: Check that all the connections are separated, then lift the unit from the vehicle

To install:
  1. Mount the igniter to the bracket.
  2.  
  3. Attach the wire lead to the coil if used.
  4.  
  5. Connect the harness.
  6.  
  7. Connect the negative battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo