Toyota Pick-ups/Land Cruiser/4Runner 1989-1996

Ignition Coil

Print

REMOVAL & INSTALLATION



External Mounted

See Figures 1 through 5

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the cover on the coil, if equipped.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Remove the cover on the coil

  1. Remove the coil wire lead.
  2.  



Click image to see an enlarged view

Fig. Fig. 2: Detach the coil wire from the unit

  1. Tag and disconnect all electrical leads to the coil. If applicable, remove the igniter.
  2.  



Click image to see an enlarged view

Fig. Fig. 3: Unplug the connector and remove the igniter

  1. Remove the two mounting bolts and lift off the ignition coil.
  2.  



Click image to see an enlarged view

Fig. Fig. 4: Loosen and remove the mounting bolts securing the coil



Click image to see an enlarged view

Fig. Fig. 5: Once all leads and bolts are removed, lift the coil from the fenderwell

To install:
  1. Install the coil in position and tighten the mounting bolts.
  2.  
  3. Connect all wires and install the igniter.
  4.  
  5. Connect the negative battery cable.
  6.  

Internal Mounted

See Figure 6

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the distributor cap and rotor.
  4.  
  5. Remove the ignition coil dust cover and dust proof packing.
  6.  
  7. Unfasten the two nuts and disconnect the three ignition coil terminals.
  8.  



Click image to see an enlarged view

Fig. Fig. 6: Exploded view of the internal mounted ignition coil distributor

  1. Remove the ignition coil retaining screws and the coil from the distributor.
  2.  

To install:
  1. Before installing, remove any old packing material from the ignition coil. Apply sealer 05523-00050 or equivalent to the coil mounting surface.
  2.  
  3. Install the ignition coil to the distributor with the four screws.
  4.  

When connecting the wires for the ignition coil, be sure the wires do not contact with the signal rotor or distributor housing.

  1. Connect the ignition coil wires and install the two nuts.
  2.  
  3. Install the dust proof packing and dust cover.
  4.  
  5. Install the rotor and distributor cap.
  6.  
  7. Connect the negative battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo