Toyota Pick-ups/Land Cruiser/4Runner 1989-1996

Radio

Print

REMOVAL & INSTALLATION



Excluding Land Cruiser
  1. If audio unit carries the designation ANTI THEFT SYSTEM, make certain you or the vehicle owner knows the security code. If the code is not re-entered after installation, the unit will not operate.
  2.  
  3. On some models you may need to remove the heater control assembly, Following the procedures given earlier in this section.
  4.  
  5. Remove the bolts holding the audio unit to the dash. Pull the unit out of the lower dash enough to allow access to the rear and sides.
  6.  
  7. Unplug the antenna cable and wiring connectors. Remove the radio with its bracket.
  8.  

To install:
  1. Fit the audio unit and bracket loosely in place; connect the antenna and wiring connectors.
  2.  
  3. Work the unit gently into position. Be careful not to pinch any wires or lines under or around the unit. Install the retaining screws.
  4.  
  5. Install the heater control assembly.
  6.  
  7. Connect the negative battery cable.
  8.  
  9. Turn the ignition switch to ACC or ON . Turn the radio on and enter the security code if one is required. Check the system for correct operation.
  10.  

Land Cruiser
  1. Disconnect the negative battery cable. Remove the ashtray. Remove the ashtray holder.
  2.  
  3. Remove the 3 screws holding the lower instrument panel trim. The trim panel is also held by six clips; each must be gently pried loose.
  4.  


WARNING
The trim panel is long and thin; it is easily broken by rough handling.

  1. Once the panel is loose, unplug the wiring connectors to the switches and remove the panel from the area.
  2.  
  3. Remove the screws holding the audio unit to the dash.
  4.  
  5. Pull the unit outward enough to allow access to the sides and back. Unplug the antenna cable and the electrical connectors. Remove the radio unit.
  6.  

To install:
  1. Loosely fit the unit into place and engage the antenna and electrical connections.
  2.  
  3. Fit the unit into the dash and install the retaining screws.
  4.  
  5. Hold the large dash panel in place and engage the wiring connectors to each switch.
  6.  
  7. Install the trim by aligning all the clips at once and gently pushing each into place. Install the retaining screws.
  8.  
  9. Install the ashtray holder and ashtray.
  10.  
  11. Connect the negative battery cable.
  12.  
  13. Turn the ignition switch to ACC or ON . Turn the radio on and enter the security code if one is required. Check the system for correct operation.
  14.  

 
label.common.footer.alt.autozoneLogo