REMOVAL & INSTALLATION
- Jack up the front of the truck and support it on jackstands.
- Remove the tension spring on the clutch fork.
- Remove the hydraulic line from the slave cylinder. Be careful not to damage the fitting.
- Remove the mounting bolts and withdraw the cylinder.
- Place the cylinder in position, and then install the bolts. Tighten to 9 ft. lbs. (13 Nm).
- Install the hydraulic line from the master cylinder.
- Bleed the system.
HYDRAULIC SYSTEM BLEEDING
This operation must be performed any time the clutch master or slave cylinder has been removed or if any of the hydraulic lines have been opened.
- Fill the master cylinder reservoir with brake fluid.
- Remove the bleeder screw cap from the clutch slave cylinder. Install a clear vinyl hose on the fitting; place the other end submerged in a clear glass jar partially filled with brake fluid.
- Have an assistant pump the clutch pedal slowly several times. After several pumps, hold the pedal down and open the bleeder, allowing fluid to flow into the jar. Close the bleeder valve almost immediately after opening it. Release the pedal only after the bleeder is closed.
- Repeat the process until the fluid in the hose contains no air bubbles in the tube. When there are no more air bubbles in the system, tighten the plug fully with the pedal depressed. Replace the plastic cap.
- Fill the clutch master cylinder reservoir, to the correct level, with brake fluid.
- Check the system for leaks.