Toyota Prius 2002-06

Multi-Function Switch

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the steering wheel.
  6.  
  7. Remove the tilt lever bracket.
  8.  
  9. Disengage the 4 claws, remove the 3 screws, and then remove the upper and lower steering column covers.
  10.  
  11. Remove the clamp and remove the turn signal switch assembly w/ spiral cable sub-assembly from the steering column.
  12.  

To install:

  1. Install the turn signal switch assembly w/ spiral cable sub-assembly to the steering column with the clamp.
  2.  
  3. Adjust the spiral cable sub-assembly as follows:
    1. Turn the spiral cable sub-assembly counterclockwise slowly by hand until it feels firm.
    2.  
    3. Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to align the marks.

      Click image to see an enlarged view

      Fig. Spiral cable sub-assembly alignment marks

    4.  

  4.  
  5. Engage the 4 claws to install the upper and lower steering column covers.
  6.  
  7. Install the tilt lever bracket with the 2 screws and tighten to 2.0 Nm (18 in. lbs).
  8.  

 
label.common.footer.alt.autozoneLogo