Toyota Sienna 2000-06

Blower Motor

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the rear No.2 seat.
  6.  
  7. Remove the right hand rear door scuff plate.
  8.  
  9. Remove the back door scuff plate.
  10.  
  11. Remove the rear right hand quarter trim plate.
  12.  
  13. Disconnect the blower motor wiring, unfasten the screws and remove the motor.
  14.  

To install:

  1. Installation is the reverse of removal.
  2.  

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Disconnect the negative battery cable.
  6.  
  7. Evacuate the A/C system using approved equipment.
  8.  
  9. Remove the scuff plates from the back door and right hand rear door.
  10.  
  11. Remove the quarter trim panel garnish.
  12.  
  13. Remove the rear headliner garnish.
  14.  
  15. Remove the rear right window side garnish assembly.
  16.  
  17. Unfasten the clips and remove the rear air duct.
  18.  
  19. Unfasten the claw retainers and remove the cover sub assembly.
  20.  
  21. Remove the air duct assembly.
  22.  
  23. Unfasten the heater hose clamp and disconnect the heater hose.
  24.  
  25. Unfasten the 2 bolts and disconnect the A/C tube and accessory assembly.
  26.  
  27. Unfasten the connectors and clamps, unplug the wiring harness and remove the blower assembly.
  28.  
  29. Unfasten the bolts and remove the blower assembly.
  30.  

To install:

  1. Installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Rear blower motor assembly and related components-2004-06 Sienna

  2.  

 
label.common.footer.alt.autozoneLogo