Toyota Sienna 2000-06

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the lower No.2 finish panel.
  6.  
  7. Remove the ECM connectors, ECM bolts and the ECM.
  8.  
  9. Disconnect the blower motor wiring, unfasten the screws and remove the motor.
  10.  

To install:

  1. Installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Removing the ECM-2000-03 Sienna



    Click image to see an enlarged view

    Fig. Removing the front blower motor-2000-03 Sienna

  2.  

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the instrument panel assembly.

    Click image to see an enlarged view

    Fig. Exploded view of the front blower motor assembly-2004-06 Sienna

  6.  
  7. Remove the clip and the heater to foot No: 1 duct.
  8.  
  9. Remove the ECM.
  10.  
  11. Remove the stereo amplifier assembly.
  12.  
  13. Release the clamps, unfasten the nuts and the wiring harness.
  14.  
  15. Remove the bolt, screws, nut and the blower assembly.
  16.  
  17. Remove the 3 screws and the blower motor.
  18.  

To install:

  1. Install the blower motor and tighten the screws.
  2.  
  3. Install the blower assembly, tighten the fasteners and attach the wiring connector.
  4.  
  5. Install the stereo amplifier assembly.
  6.  
  7. Install the ECM.
  8.  
  9. Install the heater to foot No: 1 duct and clip.
  10.  
  11. Install the instrument panel assembly.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo