Toyota Sienna 2000-06

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the manual A/C control assembly.
  6.  
  7. Place tape on the end of a screwdriver, open the claw of the cable clamp and disconnect the outer cable.
  8.  
  9. Remove the inner cable from the A/C control assembly.
  10.  

To install:

  1. Attach the outer and inner cables.
  2.  
  3. Adjust the air mix cable as follows:
    1. Set the temperature control dial to MAX. COOL and the mode dial at DEF.
    2.  
    3. Set the air mix damper control lever to cool.
    4.  
    5. Install the inner cable to the lever pin and clamp the outer cable. Lock the clamp while lightly pushing the outer cable in the direction illustrated.
    6.  

  4.  
  5. Adjust the mode cable as follows:
    1. Set the mode lever to the DEF position.
    2.  
    3. Install the inner cable to the lever pin and clamp the outer cable. Lock the clamp while lightly pushing the outer cable in the direction illustrated.
    4.  

  6.  
  7. Adjust the water valve cable as follows:
    1. Set the control lever to the COOL position.
    2.  
    3. Install the inner cable to the lever pin and clamp the outer cable. Lock the clamp while lightly pushing the outer cable in the direction illustrated.

      Click image to see an enlarged view

      Fig. Exploded view of the control cables-2000-03 Sienna



      Click image to see an enlarged view

      Fig. Install the air mix control inner cable to the lever pin and clamp the outer cable. Lock the clamp while lightly pushing the outer cable in the direction shown-2000-03 Sienna



      Click image to see an enlarged view

      Fig. Install the mode control inner cable to the lever pin and clamp the outer cable. Lock the clamp while lightly pushing the outer cable in the direction shown-2000-03 Sienna



      Click image to see an enlarged view

      Fig. Install the water valve control inner cable to the lever pin and clamp the outer cable. Lock the clamp while lightly pushing the outer cable in the direction shown-2000-03 Sienna

    4.  

  8.  

 
label.common.footer.alt.autozoneLogo