Toyota Sienna 2000-06

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Relieve the fuel system pressure.
  6.  


    Click image to see an enlarged view

    Fig. Exploded view of the fuel filter



NOTE
The fuel filter is located in the engine compartment, at the inlet line to the fuel rail.

  1. Remove or disconnect the following:

    Inlet and outlet lines from the filter
     
    Fuel filter
     

  2.  

To install:

  1. Install or connect the following:

    Fuel filter, using new O-rings. Tighten the lines to 22 ft. lbs. (29 Nm).
     
    Negative battery cable
     

  2.  
  3. Start the engine and check for leaks.
  4.  

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Disconnect the negative battery cable.

    Click image to see an enlarged view

    Fig. Exploded view of the fuel filter

  4.  
  5. Relieve the fuel system pressure.
    NOTE
    The fuel filter is located in the engine compartment, at the inlet line to the fuel rail.

  6.  
  7. Remove or disconnect the following:

    Inlet and outlet lines from the filter
     
    Fuel filter
     

  8.  

To install:

  1. Install or connect the following:

    Fuel filter, using new O-rings. Tighten the lines to 22 ft. lbs. (29 Nm).
     
    Negative battery cable
     

  2.  
  3. Start the engine and check for leaks.
  4.  

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect the negative battery cable.

    Click image to see an enlarged view

    Fig. Exploded view of the fuel filter

  4.  
  5. Relieve the fuel system pressure.
    NOTE
    The fuel filter is located in the engine compartment, at the inlet line to the fuel rail.

  6.  
  7. Remove or disconnect the following:

    Inlet and outlet lines from the filter
     
    Fuel filter
     

  8.  

To install:

  1. Install or connect the following:

    Fuel filter, using new O-rings. Tighten the lines to 22 ft. lbs. (29 Nm).
     
    Negative battery cable
     

  2.  
  3. Start the engine and check for leaks.
  4.  

 
label.common.footer.alt.autozoneLogo