Toyota Sienna 2000-06

Cables

Print

Adjustment



  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Slowly depress the parking brake pedal all the way and count the number of clicks. There should be about 3 to 5 clicks heard.
  4.  
  5. Make sure the rear brake shoe to drum clearance is properly adjusted.
  6.  
  7. Release the parking brake pedal and loosen the lock nut on the parking brake equalizer which is usually located under the vehicle on the left side.
  8.  
  9. Hold the equalizer and turn the adjusting nut until 3 to 5 clicks can be heard when apply the parking brake pedal.
  10.  
  11. Hold the adjusting nut and tighten the lock nut to 9 ft. lbs. (13 Nm).

    Click image to see an enlarged view

    Fig. Loosen the lock nut on the parking brake equalizer which is usually located under the vehicle on the left side-2000-03 Sienna



    Click image to see an enlarged view

    Fig. Hold the equalizer and turn the adjusting nut to adjust the cable tension-2000-03 Sienna

  12.  

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Remove the rear wheel.
  4.  
  5. Hand tighten the lug nuts.
  6.  
  7. Remove the hole plug from the parking brake drum on the rotor and turn the adjuster to expand the shoes until the until the rotor stops turning by hand.
  8.  
  9. Retract the adjuster about 8 turns or until the rotor can turn freely by hand.
  10.  
  11. Install the whole plug and rear wheel.

    Click image to see an enlarged view

    Fig. Adjusting the parking brake-2003-06 Sienna

  12.  

 
label.common.footer.alt.autozoneLogo