Toyota Tacoma 2002-06

Front Cover Seal

Print

Removal & Installation



Cover Installed
  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Unbolt and remove the oil pump.
  4.  
  5. Using a knife, carefully cut off the oil seal lip. With a flat-bladed tool, (preferably with tape around it) pry the seal from the cover.
  6.  

To install:

  1. Apply multi-purpose grease to the new oil seal lip.
  2.  
  3. Tap the seal into place with SST 09223-50010/60011 or equivalent seal driver, and a hammer. Do this until the seal surface is flush with the cover edge.
  4.  
  5. Install the oil pump with a new O-ring.
  6.  

Cover Removed
  1. Unbolt the timing chain cover assembly. Be careful to loosen only the correct bolts.
  2.  
  3. Pry out the seal from the cover with a flat-bladed tool.
  4.  
  5. It is a good idea to remove the oil pump from the timing cover and replace the O-ring.
  6.  

To install:

  1. Clean and inspect the timing cover area. Install new gaskets around the dowel areas and pump spline.
  2.  
  3. Apply multi-purpose grease to the new oil seal lip.
  4.  
  5. Tap the seal into place with SST 09223-50010/60010 or equivalent, and a hammer. Do this until the seal surface is flush with the cover edge.
  6.  
  7. Install the cover, tighten the bolts as specified for your engine.
  8.  
  9. If the oil pump was removed, install a new O-ring behind the pump prior to installation.
  10.  

 
label.common.footer.alt.autozoneLogo