Toyota Tacoma 2002-06

Spindle Bearings

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Front wheel
     
    Shock absorber
     
    Grease cap
     
    Driveshaft
     
    Cotter pin and lockcap
     
    Locknut, with an assistant applying the brakes
     
    Speed sensor and harness from the steering knuckle, if equipped with Anti-lock Brake System (ABS)
     
    Brake line from the steering knuckle
     
    Caliper and rotor
     
    Lower ball joint bolts and the joint from the steering knuckle
     
    Cotter pin and axle hub nut
     
    Steering knuckle
     
    Bearings from the steering knuckle
     

  4.  

To install:

  1. Install or connect the following:

    Bearings to the steering knuckle
     
    Steering knuckle
     
    Cotter pin and axle hub nut. Tighten the nut to 80 ft. lbs. (108 Nm).
     
    Lower ball joint to the steering knuckle
     
    Caliper and rotor
     
    Brake line to the steering knuckle
     
    Speed sensor and harness to the steering knuckle, if equipped with Anti-lock Brake System (ABS)
     
    Locknut, with an assistant applying the brakes. Torque the locknut to 174 ft. lbs. (235 Nm).
     
    Cotter pin and lockcap
     
    Driveshaft
     
    Grease cap
     
    Shock absorber
     
    Front wheel
     

  2.  

 
label.common.footer.alt.autozoneLogo