Toyota Tercel 1984-1994 Repair Guide

4WD Change-Over Solenoid

Print

REMOVAL & INSTALLATION



See Figure 1

This solenoid is found on vehicles with automatic transaxles.

  1. Disconnect the negative battery cable.
  2.  
  3. Raise and safely support the vehicle.
  4.  
  5. Unplug the switch electrical connections, then remove the switch attaching screws.
  6.  
  7. Pull the solenoid out from the transaxle housing.
  8.  

To install:
  1. Install the switch in the transaxle, then engage the electrical connection. Always use new gaskets and O-rings.
  2.  
  3. Lower the vehicle and check switch operation.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: 4WD change over solenoid location

 
label.common.footer.alt.autozoneLogo