Toyota Tercel 1984-1994 Repair Guide

Rear Output Shaft Seal

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the driveshaft. Refer to the procedures in this section.
  4.  
  5. Using SST 09308-10010 or an equivalent seal puller, remove the oil seal from the extension housing.
  6.  

To install:
  1. Using a seal driver, tap the seal in until it's surface is flush with the extension housing edge.
  2.  
  3. Install the driveshaft. Road test the vehicle for proper operation.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: A special puller tool is used to remove the rear output shaft seal

 
label.common.footer.alt.autozoneLogo