Toyota Tundra 2001-06

Front Crankshaft Seal

Print

Removal & Installation



3.4L Engine

NOTE
There are 2 methods to replace the oil seal, which are as follows:

4.7L Engine
  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Drain the cooling system.
  4.  
  5. Remove or disconnect the following:

    Negative battery cable
     
    Engine under cover
     
    Engine appearance cover
     
    Air intake assembly
     
    Accessory drive belt
     
    Cooling fan and pulley
     
    Radiator
     
    Drive belt idler pulley
     
    Camshaft Position (CMP) sensor connector
     
    Upper timing covers
     
    Oil cooler pipe
     
    Center timing cover
     
    A/C compressor
     
    Cooling fan bracket
     
    Crankshaft pulley
     
    Lower timing cover
     
    Timing belt. Refer to the Timing Belt unit repair section.
     
    Crankshaft timing sprocket
     
    Front crankshaft seal
     

  6.  

To install:

  1. Install the oil seal so that it is flush with the oil pump housing.
  2.  
  3. Install or connect the following:

    Crankshaft timing sprocket
     
    Timing belt
     
    Lower timing cover
     
    Crankshaft pulley. Tighten the bolt to 181 ft. lbs. (245 Nm).
     
    Cooling fan bracket. Tighten the 12mm bolts to 12 ft. lbs. (16 Nm) and the 14mm bolts to 24 ft. lbs. (32 Nm).
     
    A/C compressor
     
    Center timing cover
     
    Oil cooler pipe
     
    Upper timing covers
     
    CMP sensor connector
     
    Drive belt idler pulley. Tighten the bolt to 27 ft. lbs. (37 Nm).
     
    Radiator
     
    Cooling fan and pulley. Tighten the nuts to 16 ft. lbs. (21 Nm).
     
    Accessory drive belt
     
    Air intake assembly
     
    Engine appearance cover
     
    Engine under cover
     
    Negative battery cable
     

  4.  
  5. Fill the cooling system.
  6.  
  7. Start the engine and check for leaks.
  8.  

5vz-FE Engine
Oil Pump Body Installed
  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Negative battery cable
     
    Timing belt and crankshaft pulley
     
    Cut off the oil seal lip, using a knife
     
    Pry out the oil seal, using a suitable tool
     

  4.  


WARNING
Be careful not to damage the crankshaft.

To install:

  1. Install or connect the following:

    Apply multi-purpose grease to the new oil seal lip
     
    Tap in the new oil seal until its surface is flush with the oil pump case edge, using Seal Driver tool 09309-37010 and a mallet
     
    Crankshaft pulley and the timing belt
     
    Engine undercover, if removed
     
    Negative battery cable
     

  2.  

Oil Pump Body Removed
  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Carefully pry out the seal using a suitable tool.
  4.  
  5. Apply multi-purpose grease to the new oil seal lip.
  6.  
  7. Using Seal Driver tool 09309-37010, drive the new seal into place.
  8.  

 
label.common.footer.alt.autozoneLogo