Toyota Tundra 2001-06

Spindle Bearings

Imprimir

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Front wheel
     
    Grease cap, for 2WD
     
    Cotter pin and lock cap, for 4WD
     
    Locknut, by applying the brakes
     
    Anti-lock Brake System (ABS) speed sensor and wiring harness clamp from the steering knuckle
     
    Brake line clamp from the steering knuckle
     

  4.  


NOTE
Be careful not to damage the brake tube.



Brake caliper and disc
 

  1. Support the steering knuckle
  2.  
  3. Remove or disconnect the following:

    4 lower ball joint-to-steering knuckle bolts
     
    Upper ball joint cotter pin and loosen the nut
     
    Upper ball joint from the steering knuckle using tool 09950-40011
     
    Steering knuckle by placing it in a soft-jawed vise
     
    Inside oil seal
     
    4 bolts and shift the dust cover towards the hub side (outside)
     
    Axle hub from the steering knuckle using tools 09710-30021 and 09950-40011
     
    Dust cover from the steering knuckle
     
    Bearing spacer and ABS speed sensor (with ABS) or spacer (without ABS)
     

  4.  


WARNING
Be careful not to scratch the speed sensor rotor serrations



Outside oil seal from the steering knuckle
 
Bearing snapring from the steering knuckle
 
Bearing from the steering knuckle, using a shop press and tools 09950-60020 and 09950-70010
 



Click image to see an enlarged view

Fig. Exploded view of the front axle hub and related components

To install:

  1. Install or connect the following:

    Bearing to the steering knuckle, usin