Tucson 2006-2008

Exterior

Print

Back-up, Brake, Marker, Signal, & Tail Lights



Removal & Installation
Tail Lights
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative (-) battery terminal.
  4.  
  5. Remove the 3 screws holding the rear combination lamp.
  6.  
  7. Disconnect the wire connector.

    Click image to see an enlarged view

    Fig. Remove the 3 screws holding the rear combination lamp

  8.  
  9. Remove the rear combination lamp.
  10.  
  11. Replace the bulbs as needed: stop and tail lamp (A), turn signal lamp (B), back up lamp (C), taillight lamp (D).

    Click image to see an enlarged view

    Fig. Location of stop and tail lamp (A), turn signal lamp (B), back up lamp (C), taillight lamp (D)

  12.  

To install:

  1. Install the rear combination lamp assembly after assembling the bulb(s) and connecting the lamp connector.
  2.  
  3. Connect the negative (-) battery terminal.

    Click image to see an enlarged view

    Fig. Lighting system component locations

  4.  

Headlights




WARNING
Because the halogen bulb operates at a high temperature, dirt and oil on the bulb surface reduces the bulb-s service life. Hold the flange portion when replacing the bulb. Never touch the glass portion unless using a clean shop towel is used. Do not leave the headlight assembly without a bulb for an extended period of time. Dust, moisture, and contaminants may enter the headlight assembly affecting its performance.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative (-) battery terminal.
  4.  
  5. Remove the 2 headlight mounting bolts.
  6.  
  7. Disconnect the light connectors.

    Click image to see an enlarged view

    Fig. Remove the 2 headlight mounting bolts

  8.  
  9. Replace the headlight bulb (A), position bulb (B), and turn signal bulbs (C) as needed.

    Click image to see an enlarged view

    Fig. Location of headlight bulb (A), position bulb (B), and turn signal bulbs (C)

  10.  

To install:

  1. Install the headlight bulbs.
  2.  
  3. Connect the headlight electrical connectors.
  4.  
  5. Install the headlight assembly.
  6.  
  7. Connect the negative (-) battery terminal.

    Click image to see an enlarged view

    Fig. Lighting system component locations

  8.  

 
label.common.footer.alt.autozoneLogo