Tucson 2006-2008

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative (-) battery terminal.
  4.  
  5. Remove the crash pad lower panel (A).

    Click image to see an enlarged view

    Fig. Remove the crash pad lower panel (A)

  6.  
  7. After loosening the mounting bolts, remove the reinforcing panel (A).

    Click image to see an enlarged view

    Fig. Remove the reinforcing panel (A)

  8.  
  9. Remove the 7P connector (A) from the mode door actuator (C).
  10.  
  11. Remove the self-tapping screws (B).
  12.  
  13. Remove the mode door actuator (C) from the heater unit.

    Click image to see an enlarged view

    Fig. Remove the 7P connector (A), the self-tapping screws (B), and the mode door actuator (C) from the heater unit

  14.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  
  3. Make sure the mode door actuator (C) runs smoothly.
  4.  

 
label.common.footer.alt.autozoneLogo