Tucson 2006-2008

Starter Solenoid

Print

Removal & Installation



Specific to:

Hyundai Tucson 2006-2008

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the fuse box cover.
  4.  
  5. Remove the starter relay (A).

    Click image to see an enlarged view

    Fig. Starter relay position in the fuse box.

  6.  
  7. Install a new starter relay.
  8.  
  9. Replace the fuse box cover.
  10.  

Testing



Specific to:

Hyundai Tucson 2006-2008

  1. Disconnect the field coil wire from the M-terminal of solenoid switch.
  2.  
  3. Connect the battery as shown. If the starter pinion pops out, it is working properly. To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.  

    Click image to see an enlarged view

    Fig. Starter solenoid test

  4.  
  5. Disconnect the battery from the M terminal. If the pinion does not retract, the hold-in coil is working properly. To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.
  6.  
  7. Disconnect the battery from the body. If the pinion retracts immediately, it is working properly. To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.
  8.  

 
label.common.footer.alt.autozoneLogo