VW Passat & Audi A4 1990-2000

Electric Window Motor

Print

REMOVAL & INSTALLATION
Passat

Showing window regulator motor, or assembly carrier with window regulator, removal/installation



Click image to see an enlarged view

Fig.


NOTE
The illustration shows the removal and installation of the window regulator motor/assembly carrier with the window regulator on the rear doors. The procedure for removing and installing on the front doors is the same.



Click image to see an enlarged view

Fig. Slide a hammer shaft between the window guide and the assembly carrier until the end of the hammer shaft presses against the assembly carrier. Remove the screws and take off the window regulator motor

  1. Slide a hammer shaft between the window guide and the assembly carrier until the end of the hammer shaft presses against the assembly carrier.
  2.  
  3. Remove the screws and take off the window regulator motor.
  4.  

To install:

  1. The gearing will move when the window regulator motor is removed; it is then no longer centered. The gearing must be aligned when the window regulator motor is installed until the window regulator motor is centered again.
  2.  
  3. Installation is the reverse of the removal (see illustration).
  4.  

 
label.common.footer.alt.autozoneLogo