VW Passat & Audi A4 1990-2000

Back-up Light Switch

Print

REMOVAL & INSTALLATION
  1. Clean the area surrounding the switch on the side of the transmission as necessary.
  2.  
  3. Disconnect the switch electrical connector at the side of the transmission.
  4.  
  5. Remove the switch from the transmission by turning it counterclockwise.
  6.  
  7. Installation is in reverse order of removal making sure to install the switch with a new seal if so equipped.
  8.  


NOTE
To test the back-up light circuit remove the electrical connector at the switch and install a fused jumper wire between the two electrical terminals, turn the ignition switch to the on position and the back-up lights should operate.



Click image to see an enlarged view

Fig. Press the retaining clip in and release the electrical connector from the back-up light switch

 
label.common.footer.alt.autozoneLogo