Vibe 2003-2005

Removal & Installation

Print

  1. Remove the radio.
  2.  
  3. Remove the center knob from the HVAC control unit.
  4.  
  5. Remove the screw from the control unit.

    Click image to see an enlarged view

    Fig. Remove the center console and heater control trim panel (1)

  6.  
  7. Remove the center console and heater control trim panel.
    NOTE
    Note the routing of the cable to make installation easier.



    Click image to see an enlarged view

    Fig. Note the routing of the cable to make installation easier

  8.  
  9. Disconnect the temperature control cable from the HVAC control unit.
  10.  
  11. Disconnect the temperature control cable from the HVAC module assembly.
  12.  
  13. Remove the temperature control cable from the vehicle.
  14.  

To install:

Click image to see an enlarged view

Fig. Route the cable as previously noted

  1. Position the temperature control cable in the vehicle. Route the cable as previously noted.
  2.  
  3. Connect the temperature control cable to the HVAC module assembly.
  4.  
  5. Connect the temperature control cable to the HVAC control unit.
  6.  
  7. Install the center console and heater control trim panel.
  8.  
  9. Install the screw to the control unit.
  10.  
  11. Install the center knob to the HVAC control unit.
  12.  
  13. Install the radio.
  14.  

  1. Remove the radio.
  2.  
  3. Remove the center knob from the HVAC control unit.
  4.  
  5. Remove the screw from the control unit.

    Click image to see an enlarged view

    Fig. Remove the center console and heater control trim panel (1)

  6.  
  7. Remove the center console and heater control trim panel.
    NOTE
    Note the routing of the cable to make installation easier.



    Click image to see an enlarged view

    Fig. Note the routing of the cable to make installation easier

  8.  
  9. Disconnect the temperature control cable from the HVAC control unit.
  10.  
  11. Disconnect the temperature control cable from the HVAC module assembly.
  12.  
  13. Remove the temperature control cable from the vehicle.
  14.  

To install:

Click image to see an enlarged view

Fig. Route the cable as previously noted

  1. Position the temperature control cable in the vehicle. Route the cable as previously noted.
  2.  
  3. Connect the temperature control cable to the HVAC module assembly.
  4.  
  5. Connect the temperature control cable to the HVAC control unit.
  6.  
  7. Install the center console and heater control trim panel.
  8.  
  9. Install the screw to the control unit.
  10.  
  11. Install the center knob to the HVAC control unit.
  12.  
  13. Install the radio.
  14.  

 
label.common.footer.alt.autozoneLogo