Vibe 2003-2005

Ignition Lock Cylinder

Print

Removal & Installation



  1. Disable Zone 3 the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Chassis Electrical.
  2.  
  3. Remove the trim covers from the steering column.

    Click image to see an enlarged view

    Fig. Exploded view of ignition components

  4.  
  5. Insert the key into the ignition lock cylinder (2).
  6.  
  7. Turn the key to the ACC position.
  8.  
  9. Use a screwdriver in order to push in the stop pin on the underside of the lock cylinder case (6).
  10.  
  11. Remove the cylinder from the case.
  12.  

To install:

  1. Insert the key into the ignition lock cylinder (2).
  2.  
  3. Verify the key is in the ACC position.
  4.  
  5. Install the cylinder into the ignition lock cylinder case (6).
  6.  
  7. Verify the stop pin engages the case.
  8.  
  9. Remove the key from the cylinder.
  10.  
  11. Install the trim covers to the steering column.
  12.  
  13. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  14.  

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the trim covers from the steering column.
  4.  
  5. Insert the key into the ignition lock cylinder.
  6.  
  7. Turn the key to the ACC position.
  8.  
  9. Use a screwdriver in order to push in the stop pin on the underside of the lock cylinder case.
  10.  
  11. Remove the cylinder from the case.
  12.  

To install:

  1. Insert the key into the ignition lock cylinder.
  2.  
  3. Verify the key is in the ACC position.
  4.  
  5. Install the cylinder into the ignition lock cylinder case.
  6.  
  7. Verify the stop pin engages the case.
  8.  
  9. Remove the key from the cylinder.
  10.  
  11. Install the trim covers to the steering column.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo