Vibe 2006-2007

Brake Modulator Assembly

Print

Removal & Installation



  1. If equipped, release the Electronic Brake Control Module (EBCM) harness connector lock lever.
  2.  
  3. Disconnect the EBCM harness connector.
  4.  
  5. Remove the 6 brake pipes from the brake modulator assembly.
  6.  
  7. Plug the brake pipes in order to prevent loss or contamination of brake fluid.
  8.  
  9. Remove 2 bolts from the brake pressure modulator bracket.
  10.  
  11. Remove nut and the brake pressure modulator assembly and bracket.
  12.  
  13. Remove 3 nuts and the brake pressure modulator assembly from the bracket.
  14.  

To install:

  1. Install the brake pressure modulator assembly to the bracket. Secure with 3 nuts. Tighten the brake modulator assembly nuts to 53 inch lbs. (6 Nm).
  2.  
  3. Install the brake pressure modulator assembly and bracket. Secure with nut. Tighten the brake modulator bracket nut to 15 ft. lbs. (20 Nm).
  4.  
  5. Install 2 bolts to the brake pressure modulator bracket. Tighten the brake modulator bracket bolts to 15 ft. lbs. (20 Nm).
  6.  
  7. Remove the plugs from brake pipes and connect the brake pipes to the brake modulator assembly. Tighten the brake pipe fittings nuts to 11 ft. lbs. (15 Nm).
  8.  
  9. Connect the EBCM electrical connector.
  10.  
  11. If equipped, connect the EBCM harness connector lock lever.
  12.  
  13. Bleed the brake system.
  14.  

 
label.common.footer.alt.autozoneLogo