Vibe 2006-2007

Accelerator Pedal Position Sensor

Print

Operation



The sensor is made up of the two individual sensors within a single housing. Each sensor has a unique functionality to determine pedal position. The APP system along with the Powertrain Control Module (PCM) is used to calculate and control the amount of acceleration and deceleration through fuel injector control.

Removal & Installation



  1. Disconnect the Connector Position Assurance (CPA) from the Accelerator Pedal Position (APP) sensor connector.
  2.  
  3. Disconnect the APP sensor harness connector.
  4.  
  5. Remove the APP assembly attachment bolts from the pedal assembly.
  6.  
  7. Remove the APP assembly from the vehicle
  8.  

To install:

  1. Installation is the reverse of removal.
  2.  

Testing



  1. Check the condition of the connector. Make sure the connector is firmly attached. Check for broken or bent connector pins. Repair any connector damage before continuing with troubleshooting the issue.
  2.  
  3. Check the condition of the wiring to the connector. If the wiring is damaged, repair the wiring before continuing with any further tests.
  4.  
  5. Turn OFF the ignition.
  6.  
  7. Disconnect the accelerator pedal connector.
  8.  
  9. Turn ON the ignition, with the engine OFF.
  10.  
  11. Measure the voltage of the APP sensor 5-volt reference voltage circuit to a good ground. The reading should be 5 volts. If not check the wiring for an open, short or high resistance.
  12.  
  13. Turn ON the ignition, with the engine OFF.
  14.  
  15. Measure the voltage between the APP sensor 5-volt reference voltage circuit and signal circuit. If the reading is 5 volts replace the sensor.

    Click image to see an enlarged view

    Fig. Accelerator Pedal Position (APP) sensor terminals; (1) Low reference, (6) 5 volt reference

  16.  

 
label.common.footer.alt.autozoneLogo