Vibe 2006-2007

Flywheel

Print

Removal & Installation




NOTE
This procedure requires the use of Torque Angle Meter J 36660-A or equivalent.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the transaxle assembly, as outlined in the Drive Train Section
  4.  
  5. If equipped with a manual transmission, remove the clutch and pressure plate, as outlined in the Drive Train section.

    Click image to see an enlarged view

    Fig. Remove the eight flywheel retaining bolts.

  6.  
  7. Remove the eight flywheel retaining bolts.
  8.  
  9. Remove the flywheel from the crankshaft.
  10.  
  11. Clean any grease or dirt from the crankshaft flange outer surface using a suitable solvent.
  12.  

To install:

  1. Install the flywheel to the crankshaft.
    NOTE
    Apply the proper amount of the sealant to the fastener when assembling this component. Excessive use of the sealant can prohibit the component from being assembled properly or allow the fastener to loosen. A component or fastener that is not assembled properly can loosen or fall off leading to extensive engine damage.

  2.  
  3. Apply GM P/N 12345493 (Canadian P/N 10953488) or the equivalent, to the flywheel retaining bolt threads.

    Click image to see an enlarged view

    Fig. For vehicles equipped with an Automatic Transmission, install the flywheel retaining bolts (1-8) to the crankshaft.

  4.  
  5. For vehicles equipped with an Automatic Transmission, install the flywheel retaining bolts (1-8) to the crankshaft. Tighten the eight flywheel retaining bolts in sequence for Automatic Transmission to 61 ft. lbs. (83 Nm).

    Click image to see an enlarged view

    Fig. Tighten the eight flywheel retaining bolts in sequence for Manual Transmission.

  6.  
  7. For vehicles equipped with a Manual Transmission, install the flywheel retaining bolts to the crankshaft. Tighten the eight flywheel retaining bolts in sequence for Manual Transmission to 36 ft. lbs. (49 Nm). After the proper torque has been reached, use tool J 36660-A and tighten the flywheel bolts an additional 90 degrees.
  8.  
  9. If equipped with a manual transmission, install the clutch and pressure plate.
  10.  
  11. Install the transaxle assembly.
  12.  
  13. Connect the negative battery cable. Tighten the battery cable bolt to 11 ft. lbs. (15 Nm).
  14.  

 
label.common.footer.alt.autozoneLogo