Vibe 2006-2007

Fuel Pump


Removal & Installation

  1. Before servicing the vehicle, refer to the precautions section.
  3. Remove or disconnect the following:

    Negative battery cable

    Click image to see an enlarged view

    Fig. Exploded view of the fuel pump mounting-FWD shown, AWD similar

    Rear seat cushion and floor service hole cover
    Fuel pump and vapor pressure sensor connectors
    Start and run the engine, until it stalls

  5. Turn the ignition key to the LOCK position.

    Negative battery cable

  7. Connect the fuel pump connector.

    Fuel tank protector, AWD vehicles
    Fuel tank main tube sub-assembly
    Fuel emission tube sub-assembly No. 1, FWD vehicles
    Fuel tank vent tube set plate. The plate is secured with 8 bolts on FWD vehicles, or 5 bolts on AWD vehicles.

    Click image to see an enlarged view

    Fig. The fuel tank vent tube set plate is secured with 8 bolts on FWD vehicles

    Fuel pump assembly, being careful not to damage the filter or bend the arm of the fuel sender gauge
    Fuel suction tube set gasket
    Fuel suction support No. 2
    Fuel pump rubber cushion
    Fuel sender gauge assembly. Unplug the connector, then use a screwdriver to unlock the gauge and slide it to remove.
    Fuel section plate sub-assembly
    Vapor pressure sensor
    Fuel pump harness
    Fuel pump