Volkswagen Air Cooled 1949-1969 Repair Guide

License Plate Light

Print

REMOVAL & INSTALLATION





Click image to see an enlarged view

Fig. Fig. 1 Remove the 2 license plate lens retaining screws to gain access to the bulb

This is a general procedure and applies to all models and types covered by this guide. A few steps may need to be slightly altered to comply with your particular vehicle.

  1. Disconnect the negative battery cable.
  2.  
  3. If necessary for easier access to the light assembly lens retaining screws, open the rear hood.
  4.  
  5. Using a Phillips screwdriver, remove the light assembly lens retaining screws.
  6.  
  7. Pull the lens and gasket, if equipped, off of the license plate light assembly.
  8.  
  9. If applicable, inspect the lens gasket for tearing or crumbling. If any such damage is evident, replace the old gasket with a new one upon installation.
  10.  
  11. Once the lens is removed from the light assembly, the light bulb can be removed. To remove the light bulb:
  12.  
    1. Grasp the light bulb and gently press it in toward its socket.
    2.  
    3. While pressing the bulb in, turn the bulb counterclockwise until the two little pins on the bulb base clear the channels in the socket.
    4.  
    5. Pull the bulb up and out of its socket.
    6.  

  13. Installation is the reverse of the removal procedure. During installation, make sure that the light bulb contacts are clean and free of corrosion.
  14.  

 
label.common.footer.alt.autozoneLogo