Volkswagen Eurovan 2000-03

Locks & Lock Systems

Print

Power Door Locks



Removal & Installation
Door Lock
Front Door
  1. Remove the door trim, as outlined in this section.
  2.  
  3. Remove the bolts, then remove the outer door handle in direction of the arrow shown in the illustration.

    Click image to see an enlarged view

    Fig. Unfasten the mounting bolts (1), then remove the outer door handle in the direction of the arrow shown

  4.  
  5. Close the door window completely.
  6.  
  7. Unclip the pull-rod from retaining clips on the inner door plate.
  8.  
  9. Remove the bolts, then and remove door lock with pull rod and securing rod.

    Click image to see an enlarged view

    Fig. Remove the bolts (1), then and remove door lock with pull rod and securing rod

  10.  
  11. Installation is the reverse of the removal procedure. Tighten the door lock bolts and outside door handle bolts to 6 ft. lbs. (8 Nm).
  12.  

Door Lock Actuator
Double Rear Door
  1. Remove the rear double door trim, as outlined in this section.
  2.  
  3. Disconnect the connector from actuator.
  4.  
  5. Remove the bolts , disconnect connecting rod, then remove the actuator.
  6.  
  7. Installation is the reverse of the removal procedure.

    Click image to see an enlarged view

    Fig. Remove the bolts (1), disconnect the connecting rod (2), then remove the actuator

  8.  

Front Door
  1. Remove the door trim, as outlined in this section.
  2.  
  3. Detach the electrical connector from the actuator.
  4.  
  5. Remove the bolts, disengage the connection rod and remove the actuator.
  6.  
  7. Installation is the reverse of the removal procedure.

    Click image to see an enlarged view

    Fig. Detach the actuator electrical connector (1), unfasten the bolts (2) then disengage the connection rod and remove the actuator

  8.  

Sliding Door
  1. Remove the door trim, as outlined in this section.
  2.  
  3. Remove the bolts, then lay the actuator aside.

    Click image to see an enlarged view

    Fig. Unfasten the bolts (1), then lay the actuator aside

  4.  
  5. Disconnect the electrical connector from the actuator.

    Click image to see an enlarged view

    Fig. Detach the electrical connector (1) from the actuator

  6.  
  7. Disconnect the lock rod, then remove the actuator.
  8.  
  9. Installation is the reverse of the removal procedure.
  10.  

Tailgate
  1. Remove the tailgate trim, as outlined in this section.
  2.  
  3. Disconnect the electrical connector from the actuator.
  4.  
  5. Remove the bolts, disconnect connecting rod, then remove the actuator.
  6.  
  7. Installation is the reverse of the removal procedure.

    Click image to see an enlarged view

    Fig. Detach the electrical connector (1), unfasten the bolts (2), disconnect the connecting rod and remove the actuator

  8.  

Door Lock Switch
  1. Carefully pry out the door lock switch and disconnect the electrical connector.
  2.  
  3. Installation is the reverse of the removal procedure.
  4.  

 
label.common.footer.alt.autozoneLogo