Volkswagen Golf/Jetta/Cabriole 1990-1999

Clearing Codes

Print

WITHOUT DIAGNOSTIC TESTER



  1. To erase codes, wait until Code 4444 or 0000 is displayed.
  2.  
  3. Turn ignition switch OFF and connect jumper wire to diagnostic connectors again.
  4.  
  5. Turn the ignition switch ON and leave connectors jumpered for about 5 seconds, When Code 4444 or 0000 appears the codes will be erased.
  6.  
  7. Turn the ignition switch OFF and remove jumper wire.
  8.  

WITH DIAGNOSTIC TESTER



For both engine and automatic transaxle, after all fault codes have been retrieved, select Function 05 and press the Q button to enter the selection. The memory will be erased only if all fault codes have been retrieved. Test drive the vehicle for at least 10 minutes, including at least 1 full throttle application above 3000 rpm. Check the fault code memory again to make sure all faults have been repaired.

 
label.common.footer.alt.autozoneLogo