Volvo 240/740/760/780/940/960 1990-1998

Radio Receiver/Amplifier/Tape Player/CD Player

Print

REMOVAL & INSTALLATION



Radio/Tape Deck/CD Player

See Figures 1, 2 and 3

On most models, the radio is held in by 2 clips in the console. Remove the side covers and locate the 2 access holes (one on each side) in line with the radio case. Insert a small probe or very small screwdriver into each hole and push gently. This releases the clips and the radio may be removed from the front of the console.

Other models have the same style clips, but they are released by inserting a thin, flat probe down each side of the radio from the front. Again, release the clips and slide the radio free. Disconnect the wiring before pulling the radio too far from the dash.

The radios on some models are designed with the releases built into the front of the case. Simply push the tabs with your fingers and remove the radio.

Although these radios are relatively simple to remove, many have a security code programmed into the circuitry. Once reinstalled, the radio will not work if the correct code is not entered. The radio should not be removed or disconnected if the user code is not available.



Click image to see an enlarged view

Fig. Fig. 1: Use a small screwdriver or another suitable tool to gently depress and release the retaining tabs



Click image to see an enlarged view

Fig. Fig. 2: Grasp the tabs and pull the radio out; be careful not to pull so far that the radio falls



Click image to see an enlarged view

Fig. Fig. 3: When the connectors are accessible, unplug them. Once the connectors are unplugged, the radio will lose its memory

Amplifier
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the retaining screws from the mounting bracket.
  4.  
  5. Detach the electrical connectors from the amplifier.
  6.  
  7. Remove the amplifier.
  8.  

To install:
  1. Attach the connectors to the amplifier.
  2.  
  3. Place the amplifier in the mounting bracket.
  4.  
  5. Tighten the retaining screws.
  6.  
  7. Connect the negative battery cable.
  8.  
  9. Check the operation of the amplifier.
  10.  

CD Changer

The CD changer is located under the package shelf on sedans, above the spare tire on wagons with no third row of seats, and in the well between the second and third row of seats on wagons equipped with a third row.

  1. Remove any necessary trim to access the bracket retaining screws.
  2.  
  3. Remove the bracket retaining hardware.
  4.  
  5. Disconnect any wiring attached to the changer.
  6.  
  7. Remove the CD changer from the vehicle.
  8.  

To install:
  1. Attach the wiring to the CD changer.
  2.  
  3. Place the changer into position and tighten the retaining hardware.
  4.  
  5. Install any removed trim.
  6.  

 
label.common.footer.alt.autozoneLogo